产品中心
咨询热线:
15895891012
CROWN(皇冠)CTS专业功放
返回列表加入收藏 来源:admin 发布日期:2019-09-03 11:17:56 |
CROWN(皇冠)CTS专业功放 |
产品型号: | CTS-600 |
产品名称: | CROWN(皇冠)CTs系列专业功放 |
产品信息: | CTs 600 (120 V, 60 Hz models) The power amplifi er shall be a solid-state two-channel model employing Multi-Mode® (AB+B) output circuitry. The amplifi er shall contain protection circuitry which limits the drive level placed on the output devices before their SOA (Safe Operating Area) is exceeded. This protection circuitry shall calculate the instantaneous voltage acrosscurrent through the output devices while factoring in their simulated junction temperatures to predict how close they are to their operating limits. This protection shall be called “JTS.” The amplifi er shall contain protection from shorted, openmismatched loads, general overheating, DC, high-frequency overloads, under/over voltage, and internal faults. If an amplifi er channel starts to overheat, the Thermal Level Control (TLC) circuit shall engage that channel’s input compressor in an amount proportional to the amount of overheating, in order to generate less heat. If the channel becomes too hot for safe operation, the channel shall shut off, and the Thermal Indicator for that channel shall illuminate brightly to alert the user that a state of thermal stressoverload has caused the channel to shut down. The front-panel control shall be a power switch. Rear-mounted controls shall include Channel Level Controls, High Pass Filter Switches (one per channel),a Mode Switch. The High Pass Filter Switch shall between fl attwo positions of rolloff. The twoposition Mode Switch selects between DualBridge-Mono operation. The recommended load impedance in Dual mode shall be 2/4/8 ohms and 70V. The load impedance in Bridge-Mono mode shall be 4/8/16 ohms and 140V. The amplifi er shall be safe when driving any kind of load, including highly reactive ones. Rear-mounted output connectors shall be one four-pole touch-proof terminal strip. Rear-mounted input connectors shall be 3-pin balanced barrier connectors on the standard PIP2-BBY module. The module shall include a “Y” Input Switch which combines the input signals. The amplifi er shall be fully compatible withshall provide appropriate input cablesconnectors for Crown® PIP2 modules. The amplifi er shall be fully compatible with Harman Pro System Architectthe Crown IQ System®. |